laser engraving and cutting

Design school students and enthusiasts get to work with laser cutters and engravers. This is a high-quality tool when it comes to creating fancy designs and logos on a variety of materials, especially wood. However, if you are looking to set up shop, you need to understand that a lot of background research is necessary to get hold of the right tool. There are many factors that the amateur designer is not aware of. In the following post, we have gone over the top 5-considerations that you need to keep in mind about laser engraving. Follow our simple guide to being an expert laser engraver Canada.

1. Proper research on the machine and the suppliers

Laser machines require you to make a hefty investment. There are various concerns about machine type as well as brands. It all depends on the size, power, and the functionality that you are looking for. Bigger laser units are for bigger frames, so make your choice after you have decided on the type and size of engraving you want doing. Keep in mind that owing to the sluggish output level of some machines, the production tends to be lower. Additionally, you need to do your research about the suppliers and distributors for spare parts and maintaining a well-stocked inventory to reduce the downtime when the breakdown occurs.

2. Ensure proper setting-up of the laser machine

Lasers work with a compressor system. This is why the relative humidity of the working environment becomes vital. If you live in a country where the humidity is quite high, you need to make your choice accordingly. Figure out whether you will be able to get your device replaced or repaired if need be. Additionally, you need to make a note about the power supply and the power plugs of the unit along with other vital components like the air filter, water drainage, and the suction power during and after the installation.

3. About the compressor

The compressor is the most vital component of the laser device. It provides the air support required for the cutting and the engraving. The type and the power of the compressor are dependent upon the type and size of engraving you want to perform along with the humidity factor of the working environment. Keep in mind that after you have purchased your device, a technician will be sent by the distributor to make sure that the installation of all the components is up to the mark. Keep oil and water away from the lens during operations.

4. Installing a water drainage system

As stated before, for a humid environment, you will need a bigger and better compressor. This means the device will exhale a lot of water. Any electronic equipment is susceptible to breakdown if there is water leakage. Therefore it is vital to install a water drainage system to increase the longevity of the laser device.

5. Keep in mind the air support as well

The machine must have a regulatory mechanism for air support as well. If you are looking for cutting then keep in mind that the air support needs to be more significant. If not, then the material can catch fire.

Keep in mind these simple considerations before setting up a laser engraving service. All the best.

Related posts